cindy

/cindy

About cindy

This author has not yet filled in any details.
So far cindy has created 3 blog entries.

Injection molding cost keeps HIGH? 8 ways to reduce your injection molding cost

By | 2019-10-11T15:24:12+08:00 October 11th, 2019|Categories: Uncategorized|

1.Production workshop The layout of production workshop focuses on two aspects: meeting the production requirements, optimizing the layout according to the production process, and meeting the requirements for flexible energy use under specific production conditions. 1). The power supply has an appropriate margin while satisfying the power required for stable production, and the [...]

The reasons for robot failure

By | 2019-09-27T13:53:40+08:00 September 27th, 2019|Categories: Uncategorized|

The connecting part of the robot is mainly fixed by screws, which may be loosened due to long-term vibration, causing the robot to fall or some connecting parts to break.  On the other hand, robot vibration may cause the wire connector or relay to loosen, resulting in poor circuit contact, the robot may be out of [...]

The advantages and disadvantages you have to know about hot runners

By | 2019-09-23T11:28:29+08:00 September 19th, 2019|Categories: Uncategorized|

Advantage 1.Shorten cycle time The molding cycle is shortened. Because there is no restriction on the cooling time of the sprue system, the parts can be ejected in time after curing. Many thin-walled parts produced with hot runner molds have a molding cycle of less than 5 seconds. 2.Save plastic material For full hot runner mold, [...]

Quick links:

?????????????????????????????????????????????????????????????

This Is A Custom Widget

This Sliding Bar can be switched on or off in theme options, and can take any widget you throw at it or even fill it with your custom HTML Code. Its perfect for grabbing the attention of your viewers. Choose between 1, 2, 3 or 4 columns, set the background color, widget divider color, activate transparency, a top border or fully disable it on desktop and mobile.