Blog

/Blog
Blog 2018-11-26T04:08:37+08:00

How does the injection molding machine accurately and efficiently control the temperature of the barrel?

1.The temperature of injection molding machine barrel controlled by the microcomputer, select the appropriate algorithm to control the heating band outside the barrel of the injection machine. Ensure that the working temperature of each section of the barrel can be kept within the set range according to the technical requirements. For precise plastic injection molding, accurate temperature control is [...]

By | November 7th, 2019|Categories: Uncategorized|0 Comments

Injection molding cost keeps HIGH? 8 ways to reduce your injection molding cost

1.Production workshop The layout of production workshop focuses on two aspects: meeting the production requirements, optimizing the layout according to the production process, and meeting the requirements for flexible energy use under specific production conditions. 1). The power supply has an appropriate margin while satisfying the power required for stable production, and the surplus is not too [...]

By | October 11th, 2019|Categories: Uncategorized|0 Comments

The reasons for robot failure

The connecting part of the robot is mainly fixed by screws, which may be loosened due to long-term vibration, causing the robot to fall or some connecting parts to break.  On the other hand, robot vibration may cause the wire connector or relay to loosen, resulting in poor circuit contact, the robot may be out of control, the electronic control [...]

By | September 27th, 2019|Categories: Uncategorized|0 Comments

The advantages and disadvantages you have to know about hot runners

Advantage 1.Shorten cycle time The molding cycle is shortened. Because there is no restriction on the cooling time of the sprue system, the parts can be ejected in time after curing. Many thin-walled parts produced with hot runner molds have a molding cycle of less than 5 seconds. 2.Save plastic material For full hot runner mold, there is no cold [...]

By | September 19th, 2019|Categories: Uncategorized|1 Comment

PA66 cost soaring, how do nylon cable tie manufacture respond?

In 2018, Several leading manufacturers of PA 66 suffered from force majeure, resulting in insufficient supply of PA66 raw materials, contradiction between supply and demand, and soaring prices. Rising raw material costs are forcing more and more nylon cable tie manufacturers to adjust their raw material formulations to meet the market's low price requirements. The common manners are: 1. Replace [...]

By | June 29th, 2019|Categories: Uncategorized|0 Comments

Mold temperature controller, water type or oil type?

Mold temperature controller is a small equipment which used for heating the connected mold to obtain the correct operating temperature in a minimal or specified time and maintain the set temperature by heating or cooling. There two types of mold temperature controller on the market, oil type and water type. Heat transfer medium of mold temperature controller are water or [...]

By | June 26th, 2019|Categories: Uncategorized|0 Comments

Quick links:

?????????????????????????????????????????????????????????????

This Is A Custom Widget

This Sliding Bar can be switched on or off in theme options, and can take any widget you throw at it or even fill it with your custom HTML Code. Its perfect for grabbing the attention of your viewers. Choose between 1, 2, 3 or 4 columns, set the background color, widget divider color, activate transparency, a top border or fully disable it on desktop and mobile.