Shopping Cart

Cable Tie Manufacturing Equipment

The equipment is the key factor for the success molding. In this article, we have listed all the necessary equipment for the cable tie manufacturing, including cable tie injection molding machine, cable tie mold, and the auxiliary machine. There are brief introductions for each one, please read the following passages:

Attention: besides the equipment, raw materials operation is the part needs to be noted .The relation and principle please check the cable tie production.

1. Cable Tie Injection Molding Machine

 

In the oversea market, K288F and K358F are always the first choices for clients. Their stability is approved by time. Sometime one or two of these two model machine may already make you king in your area. Cable tie injection molding machine is the frame for the cable tie manufacturing, which should be determined firstly.

K650L and K850L machines are big machine, specially for the hot runner mold.

– optimize clamping unit for cable tie mold, which is thin and long. More durable.
– optimize barrel and screw for PA66, solved the problem of PA66 feeding and moisture remove, providing huge plasticizing ability.
– upgrade power system to assure the huge output

An machine optimized specially for cable tie manufacturing will obtain the stable and huge productive output at once.

More specification about the machine will be sent on receipt of request email.

# K288F and K358F requests cool runner mold, breve specification:

K288F-(table)

# K650L and K850L are the huge machines, special for the hot runner mold.

K650L-(table)
cable-tie

All issues  are about cable tie manufacturing: Injection molding machine, mould and raw materials and how they work together?  Cable Tie Production-Guide of 2020

mold design

All issues for cable tie mold available,drawing, inserts and more…: ☞ Cable Tie Mold – Guide of 2020

cable tie

How to inspect your cable tie quality. Difference between PA66 and PA6 cable tie…:

☞ Cable Tie Sourcing

2. Cable Tie Mold 

Cable tie mold of cool runner.

The cavities of molds must correspond with the machine, otherwise it will lead to many problems.

More detail, please check this article: cable tie mold, information for cable tie mold design drawing, mold manufacturing, attention points etc.

Cable tie size: 2.5 x 100, 140 cavities

Cable tie size: 4.8 x 400, 24 cavities

3. Auxiliary Machines for Cable Tie Manufacturing

3.1 Hopper Dryer

PA66 absorbs moisture. The plastic resin needs to be dried before production. (click the picture for more information)

3.2 Auto Loader

Load resin to the hopper once monitor that the hopper is empty.

3.3 Mixer

Mix the resin according to our formula.

3.4 Crusher

Crush the runner.

3.5 Mold Temperature Controller

Warm up the mold temperature to assure the successful molding.

3.6 Packing Machine

Vocuum, Water Injection and Seal in one station.

Avoid the application of  steam equipment, which is too large and low-efficient.

3.7 Unload Robot

Meet the requirement of high-speed cycle time of 24 hours.

Stable and safe for workers.

Stable output guarantee.

robot-hand